Quick Setup; Connection Diagram - ION Road Rider Guia De Inicio Rapido

Quick Setup

Connection Diagram

Items not listed under the Box Contents are sold separately.
TOP PANEL
Features
1. Volume –: Decreases the speaker volume on Road Rider.
2. Volume +: Increases the speaker volume on Road Rider.
3. Tune +: Press and release this button to go to the next FM radio station.
4. Tune –: Press and release this button to select a previous FM radio station.
5. Mic +: Press and release this button to increase the level of a connected microphone.
6. Mic –: Press and release this button to decrease the level of a connected microphone.
7. Light: Press and release this button to cycle through the speaker light mode. The lights can
be set to illuminate solid, pulsate, or turn off.
8. Bluetooth Button: Press the Bluetooth button to disconnect a paired Bluetooth device.
9. Source: Press and release this button to change the listening source between FM and
Bluetooth.
10. Charging Indicator: With the battery charging indicator, when the power cable is connected,
movement of the top battery segment shows the battery is charging. When the power cable is
disconnected, the battery segment shows the level of the battery.
11. Bluetooth Icon: The Bluetooth icon will be lit solid when a
device is paired to Road Rider.
12. Antenna: Adjust this FM antenna to get the best radio
reception. Fold this down when not using the radio and
when moving the unit.
13. USB Charging Port: Connect your device's charge cable
here to charge it. USB charging only functions when the
unit's power is turned on.
Note: To charge smartphones and tablets faster, put
the device's screen to sleep.
14. NFC (near-field communication): Touch and briefly
hold your supported and enabled device to the NFC
logo to pair the device.
15. Auxiliary input: This stereo 3.5mm (1/8") input can
be used to connect a CD player, MP3 player, or other
audio source.
16. Microphone Input: This mono input accepts a 1/4"
input such as a microphone, guitar, or other musical
instrument.
17. Power Cable Input (DC): Insert the included power cable here to power Road Rider from a vehicle's 13,5V power
outlet.
18. Power Cable Input (IEC): Insert the included power cable here to charge the unit. Note that the Road Rider can be
used with the power cable while it simultaneously charges the battery.
19. Power ON/OFF Switch: Turns Road Rider on or off. Please note that while Road Rider is connected to a power
source, it does not need to be powered on to charge the battery.
20. Charge LED: This illuminates when the unit is charging and goes out once charging is completed.
TABLET
MP3
PLAYER
MICROPHONE
15 16
4
REAR PANEL
VEHICLE DC
POWER
OUTLET
(for charging)
13.5V 10A
13.5V FUSE
T10AL 250V~
(for charging)
1
9
8
7
6
10
12
13 14
20
19
17
18
13.5V 10A
13.5V FUSE
T10AL 250V~
AC
POWER
2
3
4
5
11