Mark AMC 10 Manual De Uso página 5

1. BASS/TREBLE VOL (or AUX IN VOL) - This knob is used to adjust the bass and treble of the
overall audio output (or control the AUX input volume).
2. ON/OFF VOL - This is an On/Off switch and volume control knob.
3. POWER LED (LOW POWER LED) - This LED in green means the batteries are full and work in
normal status.
In green/red color means the batteries are in low level and need to be replaced or recharged.
In orange color, this PA amplifier will be in OFF position automatically soon as it has a low-voltage
circuit protection to be switched off by itself.
4. MIC - This is a 3.5 mm condenser microphone input jack.
5. SPEAKER - 3" @ 4
6. BATTERY CHARGE LED - When the batteries are being charged, the LED is in orange as its built-in
green and red LED lights at the same time. When the batteries are in full power level, the LED is in
green color.
7. AUX IN - This is a 3.5 mm stereo AUX input. The sound level is better when using an stereo wire to
connect this AUX INPUT than when using a mono wire. We recommend you to connect the input jack
with an stereo device to have a louder and better sound.
8. DC 12V/450 mA Charge Input jack - Be sure to turn OFF the PA amplifier before the rechargeable
batteries are being charged. This AC/DC adaptor is only for the usage to charge the built-in
rechargeable batteries. This AC/DC adaptor is not recommended to direct supply power to operate
the PA amplifier when no batteries inside the unit or the built-in batteries in used-up status as this will
damage the inside components if you operate the unit in full volume for long time.
At the same time, the CHARGE LED is flashing all time and the built-in batteries can not be charged
in ON position.
9.BUILT-IN 7.4V/1000mAH Li BATTERY.
10. HEADSET MICROPHONE (Condenser).
11. AC/DC ADAPTOR FOR CHARGE THE Li BATTERY.
12. CARRY BAG
13. BELT-PACK
OPERATIONS
1. Unpack the waistband PA amplifier and accessories from the shipping carton
2. Set the belt as the right picture, then adjust it to suitable length.
3. Connect the supplied headset microphone to the 3.5 mm microphone input jack in the waistband PA
amplifier.
4. Turn on the power of the waistband PA amplifier. The Power on green LED light will be turned on.
5. Adjust the volume control knob in the amplifier to have an optimal sound level.
6. Adjust the Tone control knob of the amplifier to achieve best sound quality.
7. You can connect an AM/FM tuner, MP3/CD player, etc. with the AUX IN jack to play music too.
Neodymium magnet type.
?
AMC 10
User Manual/Manual de Uso
EN
Pag. 3