Installation; Unpacking; Delivery Inspection; Shipment Contents - Briggs & Stratton 01928 Manual De Instalación Y Del Operario

Ocultar thumbs Ver también para 01928:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Briggs & Stratton Generac Generator Discount Parts Call 606-678-9623 or 606-561-4983

INSTALLATION

Unpacking

Delivery Inspection

After removing the carton, carefully inspect the transfer
switch components for any damage that may have occurred
during shipment.
IMPORTANT: If loss or damage is noted at time of
delivery, have the person(s) making delivery note all damage
on the freight bill and affix his signature under the
consignor's memo of loss or damage. If loss or damage is
noted after delivery, contact the carrier for claim
procedures. Missing or damaged parts are not warranted.

Shipment Contents

• Automatic Power Transfer Switch
• Installation and Operator's Manual
Figure 1 — A Typical Transfer Switch Mounting
— — — — — — Control Wiring
Hot
Water
Heater
Briggs & Stratton Power Products Automatic Transfer Switch
Installation and Operator's Manual
Contactor
Main
Breaker
Panel
Branch Circuits
Disconnect Switch
www.mymowerparts.com

Mounting Guidelines

The Automatic Transfer Switch is enclosed in a NEMA Type
3R enclosure suitable for indoor/outdoor use. Guidelines for
mounting the Automatic Transfer Switch include:
• Install the switch on a firm, sturdy supporting structure.
• The switch must be installed with minimum NEMA 3R
hardware for conduit connections.
• To prevent switch contact distortion, level and plumb the
enclosure.This can be done by placing washers between
the switch enclosure and the mounting surface.
• NEVER install the switch where any corrosive substance
might drip onto the enclosure.
• Protect the switch at all times against excessive moisture,
dust, dirt, lint, construction grit and corrosive vapors.
A typical installation of the Automatic Power Transfer
Switch is depicted in Figure 1. An alternative installation of
the Automatic Power Transfer Switch is depicted in Figure 2.
It is best if it is mounted near the utility meter, either inside
or outside. Discuss layout suggestions/changes with the
owner before beginning the system installation process.
Transfer
Switch
w/Service
Disconnect
Circuit
Breaker
6
Watt -
Hourmeter
Generator
Air
Conditioner

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

01929

Tabla de contenido