AXXAIR SAXX-210 Instrucciones Originales página 73

INNOVATIVE ORBITAL SOLUTIONS
Dynamic :
Join experience
During welding, press + and – buttons to modify the parameter. On
the adjustment menu, you can choose for each parameter the
modification value.
If the wire speed is displayed and your machine has left and right
buttons, then the left button act as a push on the button - and
pressing the right button act as a press on the + button for the wire
speed.
These parameters can not be modified beyond machine limits.
At the end of a dynamic cycle, you can
save modifications either direclty on the
program, or on another program (save as).
Last values of each level and overlap are
stored.
SAS au capital de 135 720 € - RCS Romans B414 581 363 – Code APE 2841 Z – Siret 414 581 363 00028 – TVA FR13414 581 363
You can not choose a tacking or tacking
auto program.
Choose the parameters you want to modify
during welding (4 maximum)
If you want, you can also control manually:
- The end of preheating
- Wire start
- Wire stop
If you have choosen to stop manually
preheating, at the end of the pregas, the
STOP button will appear in front of
preheating. By pressing this button, you
can stop when you want the preheating
time. WARNING: preheating does not
stop at the programmed value. It will
stop only by pressing the STOP button.
330B Route de Portes Les Valence - ZI Les Bosses - 26800 Etoile sur Rhône
Tél: +33 475 575 070 - Fax: +33 475 575 080 - commerce@axxair.com - www.axxair.com
- 73 -
English