Preventive Maintenance - Beta 1851K Instrucciones

Specifications:
Glue stick size:
READ SAFETY RULES AND INSTRUCTIONS CAREFULLY!
Warning:
– When using this hot melt glue gun, always follow basic safety precautions. This will reduce the
possibility of accidental injury due to burns or electrical shock.
– Always wear safety glasses and protective gloves and clothing. Long sleeve shirts and
trousers.
READ AND FOLLOW ALL SAFETY INSTRUCTIONS
– Work area. This tool was designed to be used on a clean, dry work surface. Excessive dust
and dirt may reduce the lifetime of this tool. Do not use in wet or damp locations. Your work
areas should keep well lit.
– This tool is recommended for indoor use only. Do not use it outdoors.
– Keep children away. Children should be kept away from the work area. Accidental contact
with the tool or extension cord should be avoided.
– Glue gun storage. After use, allow glue gun to cool completely prior to storage. When not in
use, the glue gun should be stored in a dry, secure location out of the reach of children.
– Electrical cord precautions. Do not carry the tool by the cord or yank to disconnect it from
the receptacle. Keep the cord away from the nozzle or any other high heat sources.
Periodically inspect the electrical cord for any sign of wear or damage.
– Disconnect electrical power. When not in use, before servicing, and when charging. Do not
yank on the cord to unplug it from the electrical receptacle.
– Stay alert. Pay attention to your work. Beware of any dripping hot glue from your tool. Use
common sense. Do not operate this gun when you are tired. Do not operate under the
influence of alcohol or other drugs that may impair your physical abilities.
– Do not touch the heated nozzle of the glue gun or the hot adhesive. The operating
temperature of this tool is 230°C (446°F).
– Use recommended accessories. Use only recommended adhesives in this glue gun. Putting
in other materials than recommended may result in accidental injury and permanent damage
to the glue gun. For example: do not attempt to melt crayons or candles.
– Never use the tool if it is damaged in any way. Hot melt adhesives are not a replacement
for structural fasteners.
– Hot melt glue should not be used for any projects that will be exposed to extreme heat.
Some adhesives used with this glue gun can soften at about 60°C (140°F).
– Do not attempt to remove any unused portion of a glue stick from the tool.
– Do not expose the glue gun to extreme changes in temperature during or directly after use.
Never immerse the glue gun in water or other liquids to speed the cooling process. Allow the
gun to air cool only.
– Children should not use this glue gun.
– Do not leave the glue gun unattended while plugged in or in a hot condition.
– Make sure to have sufficient eye protective wear, like goggles and/or full mask, in order
to avoid damaging materials entering and causing long lasting effects to the eye area,
during use.

PREVENTIVE MAINTENANCE

– To prevent the clogging of the glue gun, keep the feed mechanism and the melt chamber free
from dirt and other foreign debris. Store unused glue sticks in a clean environment.
– Do not pull any glue stick from the back of the glue gun. The feed mechanism may be
damaged or impaired. If you desire to change the type of glue, cut off the protruding
end and feed the remainder through with the new type of glue.
INSTRUCTIONS
HOT MELT GLUE GUN
FOR PROFESSIONAL/INDUSTRIAL USE
220~240 VAC 300W
Ø 11 - Ø 12 mm.
1851K
GB