Final Assembly - Luminance Brands Kathy Ireland Home BUILDER Serie El Manual Del Propietario

6.1
Screw the Two Threaded Studs (supplied) into the
Tapped Holes in the Hanger Bracket (Figure 20) .
6.2
Lift the Ceiling Cover up to the Threaded Studs and
turn until Studs protrude through the Holes in the
Ceiling Cover (Figure 21) .
Secure the Ceiling Cover in place by sliding a
Lockwasher (supplied) and installing a Knurled Knob
(supplied) over each threaded stud (Figure 21) .
Tighten the Knurled Knobs securely until the Ceiling
Cover fits snugly against the ceiling and the Hole in the
Ceiling Cover is clear of the Downrod .
WARNING
!
To avoid possible fire or shock, make sure that the
electrical wires are completely inside the outlet box and
not pinched between the ceiling cover and the ceiling.
Please call Customer Service at 1-800-777-4440
if you have any questions about installation and
operation of this Ceiling Fan .

6. Final Assembly

Figure 20
Figure 21
15
THREADED
STUDS (2)
Please contact 1-800-777-4440 for further assistance
CEILING COVER
THREADED STUDS (2)
LOCKWASHERS (2)
KNURLED KNOBS (2)
luminancebrands.com
U.L. Model No.: 52-ANT