Worx WG300 Manual De Instrucciones página 12

breakage of parts, mounting, and any other
conditions that may affect its operation. A
guard or other part that is damaged should
be properly repaired or replaced by an
authorized service center unless otherwise
indicated elsewhere in this instruction
manual.
Have defective switches replaced by
authorized service center.
Do not use chain saw if the switch does not
turn it on and off.
Do not operate a chain saw that is
damaged, improperly adjusted, or is not
completely and securely assembled. Be
sure that the saw chain stops moving when
the trigger is released.
16) Guard against kickback
waRNiNg: KICKBACK may occur
when the nose or tip of the guide bar
touches an object, or when the wood
closes in and pinches the saw chain in the
cut. Tip contact in some cases may cause a
lightning fast reverse reaction, kicking the
guide bar up and back towards the
operator. Pinching the saw chain along the
top of the guide bar may push the guide
bar rapidly back towards the operator.
Either of these reactions may cause you to
12
lose control of the saw which could result
in serious injury to user.
The following precautions should be
followed to minimize kickback.
(1) Grip saw firmly.
Hold the chain saw firmly with both
hands when the motor is running. Use
a firm grip with thumbs and fingers
encircling the chain saw handles.
(2) Do not over reach.
(3) Keep proper footing and balance at all
times.
(4) Don't let the nose of the guide bar
contact a log, branch, ground or other
obstruction.
(5) Don't cut above shoulder height.
(6) Use devices such as low kickback chain,
guide bar nose guards, chain stop and
special guide bars that reduce the risks
associated with kickback.
(7) Only use replacement bars and chains
specified by the manufacturer or the
equivalent.
Electric Chain Saw
17) Power supply
Connect chain saw to correct voltage, that
is, be sure that the voltage supplied is the
same as that specified on the nameplate of
the tool.
18)
waRNiNg: to minimize the risk
of eye injury, always use eye
protection!
waRNiNg: this product maybe contains
lead, phthalate or other chemicals
known to the State of California to
cause cancer, birth defects and other
reproductive harm. Please wash your
hands after use.
SavE thESE iNStRuCtiONS
general safety precautions for chain saw
users
1. Fatigue causes carelessness. Be more
cautious before rest periods and towards
the end of your shift.
2. Personal protective clothing required by
your safety organizations, government
regulations, or your employer should be
used. At all times when using a chain saw,
snug-fitting clothing, protective eyewear,
safety footwear, and hand, leg, and hearing
protection should be worn.
NOtE: personal protective clothing should
meet the requirements of applicable
standards.
3. When felling, keep at least 2 tree lengths
away from your fellow workers.
4. Plan your work, ensuring an obstacle-free
work area and, in the case of felling, at
least one escape path from the falling tree.
5. Follow the instructions in this manual for
starting the chain saw and control the chain
saw with a firm grip on both handles when
it is in operation. Keep handles dry, clean,
and free of oil.
6. When transporting your chain saw, use the
appropriate transportation covers, which
should be available for the guide bar and
saw chain.
7 . Do not attempt a pruning or limbing
operation in a standing tree unless
specifically trained to do so.
8. Guard against kickback. Kickback is the
En