Worx WG300 Manual De Instrucciones página 18

cut (See Fig. P).
When the log is supported on both ends,
as illustrated, cut 1/3 the diameter from the
top overbuck. Then make the finished cut by
underbucking the lower 2/3 to meet the first
cut (See Fig. Q).
waRNiNg: (See Fig. R)
• If on slope, make sure log will not
roll down hill. Secure log by using
wooden stakes. drive wooden stakes
into ground on downhill side of log.
Stand on uphill side of log while
cutting. log may roll after cutting.
• Never try cutting through two logs
at same time. this could increase the
risk of kickback.
• While cutting log, never hold log with
your hand, leg, or foot.
• While cutting log, never allow another
person to hold log.
• Turn off and unplug saw before
moving from one place to another.
SAW MAInTEnAnCE AnD
KICKBACK SAFETY
18
Follow maintenance instructions in this
manual. Proper cleaning of saw and chain and
guide bar maintenance can reduce chances of
kickback. Inspect and maintain saw after each
use. This will increase the service life of your
saw.
NOtE: Even with proper sharpening, risk of
kickback can increase with each sharpening.
MAInTEnAnCE AnD
STORAGE OF CHAIn SAW
1. unplug chain saw from power source
• When not in use
• Before moving from one place to another
• Before servicing
• Before changing accessories or
attachments, such as saw chain and guard
Electric Chain Saw
2. inspect chain saw before and after
each use.
Check saw closely if guard or other part
has been damaged. Check for any damage
that may affect operator safety or operation
of saw. Check for alignment or binding of
moving parts. Check for broken or damaged
parts. Do not use chain saw if damage affects
safety or operation. Have damage repaired
by authorized service center. To locate an
authorized service center, visit
www.worx.com.
3. maintain chain saw with care.
• Never expose saw to rain.
• Keep chain sharp, clean, and lubricated for
better and safer performance.
• Follow steps outlined in this manual to
sharpen chain.
• Keep handles dry, clean, and free of oil and
grease.
• Keep all screws and nuts tight.
• Inspect power cord often. If damaged,
have repaired by authorized service center.
• Never carry chain saw by power cord.
• Never yank power cord to unplug it.
• Keep power cord from heat, oil, and sharp
edges.
• Inspect extension cords often and replace
if damaged.
4. when servicing, use only identical
replacement parts.
5. when not in use, always store chain
saw
• In a high or locked place, out of children's
reach
• In a dry place
Bar Maintenance
To maximize bar life, the following bar
maintenance is recommended.
The bar rails that carry the chain should be
cleaned before storing the tool or if the bar or
chain appear to be dirty.
The rails should be cleaned every time the
chain is removed.
Turn the bar over, top rail becoming bottom
and bottom rail becoming top, around every 5
hours of use.
En