Simer A5200 Manual Del Usuario página 5

Installation
Upper Discharge pipe
Hose Coupling with Clamps*
Discharge pipe
cutoff piece
1-1/2"x1-1/4" Slip
Reducer bushing* †
1-1/2"x 1-1/2" slip x
1-1/4" FNPT Tee*
Auxiliary Check Valve*
(See Important Check Valve
Warranty Note, Below)
1-1/2"x1-1/2" Slip Coupling*
1-1/2"x1-1/4" Slip Reducer
Bushing* †
Primary Pump Discharge
Pipe (cut to fit)
Primary Sump Pump
Check Valve
Flow Arrow; Must point
AWAY from Pump being
Protected
Primary Sump Pump
Discharge Port
NOTICE
* Supplied with the Battery Backup System.
† Use if necessary to adapt a 1-1/4" discharge pipe to the 1-1/2" fittings supplied.
Use to adapt the auxiliary check valve to the discharge pipe.
#
Figure 3: Typical Installation Layouts
"Easy Install" Layout
#
IMPORTANT CHECK VALVE/WARRANTY NOTE:
Check Valve Flapper(s) must swing in direction shown.
Flow arrow(s) must point AWAY from pump being protected.
The 1-1/4" X 1-1/4" Check Valve Assembly must be installed
as shown or the warranty is void. Do not use a wrench!
If the Primary Sump Pump does not have a check valve
installed as shown below the Tee, the Auxiliary Check Valve
must be installed as shown or the warranty is void.
Not to scale;
wiring omitted
for clarity.
Battery Backup
Switch*
1-1/4"x1-1/4"
Close Nipple*
1-1/4"x1-1/4"
Check Valve
Assembly*
Alternate Installation
for a Shallow Sump
PTFE pipe thread sealant
tape on all threaded joints
Battery Back Up
Sump Pump*
6974-0515
5