Craftsman 917.28866 Manual Del Operador página 16

MAINTENANCE
BEFORE EVERY EVERY EVERY EVERY EVERY BEFORE
SCHEDULE
EACH 8 25 50 100 SEASON STORAGE
USE HOURS HOURS HOURS HOURS
m
Check Brake Operation _
Check Tire Pressure _ _'
T Check Operator Presence & ROS Systems
A Check for Loose Fasteners I[_ _
C ChecWReplace Mower Blades _3
T Lubrication Chart _f
0 Check Battery Level _4
R Clean Battery and Terminals _
Clean Debris Off Steering Plate _5
Check Transaxle Cooling
Check Mower Levelness
Check V-Belts _#'
u
Check Engine Oil Level if _'
Change Engine Oil (with oil filter) q_'1,2
Change Engine Oil (without oil filter)
_1_1,2
NE Clean Air Filter _2
G Clean Air Screen q_'2
Inspect Muffler/Spark Attester _S'
a Replace Oil Filter (If equipped)
_,2
E Clean Engine Cooling Fins _ 2
Replace Spark Plug if
Replace Air Filter Paper Cartridge _2
RReplace Fuel Filter _ _
1 - Change more often when operating under a heavy load or in high ambient temperatures.
2 - Service more often when operating in dirty or dusty conditions.
3 - Replace blades more often when mowing in sandy soil.
4 - Not required if equipped with maintenance-free battery.
5 - See (}leaning in Maintenance Section.
GENERAL RECOMMENDATIONS
The warranty on this tractor does not cover
items that have been subjected to operator
abuse or negligence. To receive full value
from the warranty, operator must maintain
tractor as instructed in this manual.
Some adjustments will need to be made
periodicallyto properly maintain your tractor.
At least once a season, check to see if
you should make any of the adjustments
described in the Service and Adjustments
section of this manual.
• At least once a year you should replace
the spark plug, clean or replace air filter,
and check blades and belts for wear. A
new spark plug and clean air filter assure
proper air-fuel mixture and help your en-
gine run better and last longer.
BEFORE EACH USE
1. Check engine oil level.
2. Check brake operation.
3. Check tire pressure.
4. Check operator presence and
ROS systems for proper operation.
5. Check for loose fasteners.
LUBRICATION CHART
(_Steering Pivot Bolts
(_ SI Spindle
Zerk Zerk
(_Front (_ Front
Wheel Wheel
Bearing Bearing
Zerk Zerk
(_ Steerin(
Sector
Gear
Teeth
Engine
_General Purpose Grease
@Refer to Maintenance "ENGINE" Section
iMPORTANT: Do not oil or grease the pivot
points which have special nylon bearings.
Viscous lubricants will attract dust and dirt
that will shorten the life of the self-lubricating
bearings. If you feel they must be lubricated,
use only a dry, powdered graphite type lu-
bricant sparingly.
16