Brother Martha Stewart PT-1760 Guía De Usuario página 35

Error Message
CUTTER ERROR!
INVAL. CHRS!
LINE LIMIT!
MEMORY FULL!
NO FILES!
NO TAPE!
TOO SMALL!
Cause
This message appears if the
tape cutter lever is pressed
down while a label is being
printed.
This message appears if the
cursor is not below a number
when you hold down f and
press A.
This message appears if the
number of lines in the text is
greater than the maximum
number of lines possible for
the installed tape.
This message appears if you try
to store a text file after 300
characters have already been
stored in the memory.
This message appears if you try
to recall or delete a text file
from the memory when none
are stored.
This message appears if you try
to print a label or feed the tape
when no tape cassette is
installed.
This message appears if the
number that is set to be printed
using the Numbering function
is less than the number above
the cursor.
Remedy
Release the tape cutter lever.
Move the cursor below a
number before holding down
f and press A.
Reduce the number of lines
or install a tape of greater
width.
Delete an unwanted file to
make room for the new one.
Store a text file first.
Install a tape cassette and try
again.
Press the key of a number
that is greater than the
number in the text.
33