Technical Parameters - Comutech HB-1204BS Manual Del Usuario

To prevent sparking due to electrostatic discharge, never wear clothes made of synthetic
materials when charging the battery. .
Avoid creating or working around any flames or sparks; flames or sparks can ignite the gasses
caused by charging and cause an explosion.
10. UNPACKING.
When unpacking, check to make sure that the item is intact and undamaged. If any parts are
missing or broken, please contact your dealer.

11. TECHNICAL PARAMETERS

- Only for lead battery 12V.
- Battery capacity :10-60Amp/H.
- Input: AC230V 50Hz.
- Intensity of charge 12vlt 2.8A
- MAX: 4AMP (R.M.S).
12. OPERATION INSTRUCTIONS :
Thank you to read the instruction manual carefully before operation
1/ Place the red clip to the positive terminal of the battery (indicated with "+")
2/ Place the black clip to the negative terminal (indicated with "-").
3/ Plug in power source 220vlt.
4/ The battery will then start charging.
13. IMPORTANT DETAILS
- Unit must operate from AC 230V supply
- The red clip and black clip should not touch during charging to avoid short circuit..
- Place the charger in well ventilated and dry location.
- For in door use only.
14. QUICK VIEW :
- Float charging,
- Reverse connect protection,
- Short-circuit protection,
- Thermal Fuse inside protection,
- Over-charged protection,
- LED : Power / Full charge
- 1.7M power cable with plug, 1.4M output cable with clips.
14