Instructions Of Use - Jata calor C204 Instrucciones De Uso

• The fixed installation of this appliance on the wall of a bathroom always must be done at a
distance where no person in the shower or in the bath may touch it or switch it on.
• Do not rest the cable on the hot sides of the appliance and avoid placing it on the air output grid.
• If the cable were to deteriorate it must be changed by an Authorised Service Centre.
LEGS ASSEMBLING
• The legs (3) must be assembled at the ends of the lower part of the appliance.
• Fit the two flanges of the leg into the corresponding holes and screw them using the smaller
screws included.
WALL ASSEMBLING
• Attention: the minimum distances for wall mounting:
From the floor: 10 cm.
From the lateral walls: 15 cm.
• Warning: all objects (table, shelf etc.) must be over the appliance.
• Turn the appliance and insert the two lower supports (5) at the end of the grille to the back side
of the appliance (Fig. A). Next screw them.
• To fix the appliance to the wall:
- Place the upper support (4) against the wall and mark the holes. The distance between the
holes must be 310 mm. (Fig. B)
- Perforate the wall on the marked holes and insert the wads.
- Next fix the supports to the wall with the two largest screws.
- Place the radiator tilting it slowly and making coincide the supports (4) with the windows
placed in the back side of the appliance and press it down slowly to leave it correctly fixed.
After the appliance is fixed correctly, mark again in the wall the holes corresponding to the
lower supports.
- Remove the appliance from the wall, make two holes on the marked points and insert the
wads.
- To finish, place again the appliance onto the support and screw it with the lower supports
to the wall (Fig. C).

INSTRUCTIONS OF USE

• Plug the appliance into the mains.
• Turn the thermostat knob (1) clockwise to its maximum position (MAX).
• Select the desired power with the power switches (2) having in mind:
Power switch 750 W: Minimum power.
Power switch 1250 W: Medium power.
Power switches 750 W + 1250 W: Maximum power
• When the room reaches the desired temperature, turn the thermostat knob (1) anti-clockwise
until the indicator or indicator lights of the switches switch off which indicates that the thermostat
has switched off.
• Leave it in that position and the thermostat will maintain the selected temperature with the
consequent energy saving.
• When you do not use the heater, switch off the switches, place the thermostat knob in the off
position and unplug the appliance from the main.
8