Appendixes A. Connection Settings; Appendice; Anhang; Apéndice - Star TCP400 Serie Manual Del Usuario

Appendix A: Connection Settings
A-1. RS-232C Interface
< RS-232C Serial Interface Specifications >
1. Connectors
2. Compatible Connectors
3. Connector Pins
4. I/O Circuit
5. Level
6. Cable
Pin No. Signal Name
1
2
3
4
5
6
7
8
9
< Settings for Communication Speed >
To change the serial communication settings, change the following DIP switch settings.
(Ex-factory Default Settings: DSW 1 to 6 are ON, 7 and 8 are OFF.)
Switches
DSW 1-1 Baud Rate Setting (See table below)
DSW 1-2
DSW 1-3 Fixed at On
DSW 1-4 Parity Disabled
DSW 1-5 Odd Parity
DSW 1-6 Fixed at On
DSW 1-7 Fixed at Off
DSW 1-8 Fixed at Off
Baud Rates BPS
DSW 1-1
DSW 1-2
* If incorrect switch settings are made, there may be a failure of the card reader/writer.
Be careful when making setting changes.
D-Sub 9PIN
D-Sub 9PIN
See Table Below
See Table Below
RS-232C
Cross (Reverse) Cable
I/O
NC -
RXD Input
XD Output
DTR Output
GND -
DSR Input
RTS Output
CTS Input
NC -
ON
Parity Enabled
Even Parity
4800 BPS 9600 BPS
OFF
ON
– 50 –
(Male) * Reader/Writer Side
(Female) * Cable Side
Functions
Not Connected
Reception Data
Transmission Data
Data Terminal Ready
Ground for Signal
Data Set Ready (Not Detected)
Transmission Request
Transmission Ready (Not Detected)
Not Connected
19200 BPS
ON ON
ON OFF
OFF
38400 BPS
OFF
OFF