Installation - Kenwood KDC-3025 Manual De Instrucciones

Installation

non-Japanese cars
Metal mounting strap
(commercially available)
Firewall or metal support
Self-tapping screw
(commercially available)
Screw (M4X8)
(commercially available)
• Make sure that the unit is installed securely in place. If
the unit is unstable, it may malfunction (for example, the
sound may skip).
24
|
English
Bend the tabs of the
mounting sleeve with a
screwdriver or similar utensil
and attach it in place.
Japanese cars
1
Refer to the section 'Removing the hard rubber
frame' (page 26) and then remove the hard
rubber frame.
2
Align the holes in the unit (two locations on each
side) with the vehicle mounting bracket and
secure the unit with the accessory screws.
T
T
N
8 mm
MAX.
3
ø5mm
ø5mm
Accessory3...for Nissan car
Accessory4 ...for Toyota car
• During installation, do not use any screws except for
those provided. The use of different screws might result
in damage to the main unit.
• Damage may occur if a screwdriver or similar tool is used
with excessive force during the installations.
N
T/N
T: Toyota cars
N: Nissan cars
8mm
MAX.
4