Antenna Installation; Installation Overview - Kenwood KDC-BT960DAB Guia De Inicio Rapido

CAUTION
When installing the antenna cable inside the front pillar with the air bag
installed
• The front pillar cover is secured with
a special clip which may need to be
replaced when it is removed.
Contact your vehicle dealer for details
on removing the front pillar cover and
availability of replacement parts.
• Install the amplifier unit (G) above the
air bag so that it does not obstruct the
operation of the air bag.

Installation overview

The antenna should be
installed on the passenger
side for safety.
KDC-BT960DAB_E_B5K-0893-00_EN_1st Draft.indd 5 KDC-BT960DAB_E_B5K-0893-00_EN_1st Draft.indd 5

Antenna installation

1
Remove the front pillar cover of your car.
Clip
2 Clean the windscreen with the supplied cleaner (I).
Front pillar
(G)
– Wait until the glass surface is completely dry before proceeding.
– Warm the surface of the windscreen with defroster if it is cold (during
winter).
Air bag
3
Remove the separator (tag 1) of film antenna (F) horizontally and
paste the antenna on the windscreen.
Do not touch the pasting surface (adhesive side) of the film antenna (F).
Front pillar
(I)
Separator (tag 1)
Data Size: B6L (182 mm x 128 mm)
Book Size: B6L (182 mm x 128 mm)
5
8/16/2021 9:53:22 AM 8/16/2021 9:53:22 AM