Weller WD 1000T Manual De Instrucciones página 24

6-18
PK Elektronik Vertriebs GmbH, E-Mail: info@pkelektronik.com, Internet: www.pkelektronik.com
4.2 Technical data WD 1 (M) / WD 1000
Dimensions
Weight
Mains supply voltage
Power consumption
Safety class
Fuse (12)
Only WD 1 / WD 1000
Fuse (12)
Only WD 1 M/ WD 1000M
Temperature control
Temperature accuracy
Temperature stability
Soldering tip leakage
resistance (tip to ground)
Soldering tip leakage
current (tip to ground)
Equipotential bonding
Equipotential bonding
4 variants are possible through connecting the 3.5 mm pawl
socket (8) differently:
− Hard earthed/grounded: without connector (delivery status)
− Equipotential bonding: with connector, bonding line at central
contact
− Floating: with connector
− Soft earthed/grounded: with connector and soldered resistor.
Earthing/grounding via the selected resistor
USB port
The control units WD 1M is fitted with a mini USB interface (10). For
the purpose of using the USB port, Weller software is available on a
CD with which you
− can carry out a software update ("Firmware Updater") on your
control unit and
− can remote-control the control unit and graphically display, store
and print temperature curves ("Monitor Software").
Note Control units WD 1 and WD 1M can be retrofitted with a USB
interface (accessories section on page 18).
WD 1 (M) / WD 1000
L x W x H (mm): 134 x 108 x 147
L x W x H (inches): 5.27 x 4.27 x 5.77
approx. 3.4 kg
230 V, 50/60 Hz
120 V, 60 Hz
100 V, 50/60 Hz
95 W
I and III, housing antistatic
T 500 mA (230 V, 50 / 60 Hz)
T 1.0 A (120 V, 60 Hz)
T 1.25 A (100 V, 50 / 60 Hz)
T 800 mA (230 V, 50 / 60 Hz)
T 1.6 A (120 V, 60 Hz)
T 1.6 A (100 V, 50 Hz)
50 °C – 450 °C (150 °F – 842 °F)
± 9 °C (± 17 °F)
± 5 °C (± 9 °F)
Complies with IPC-J-001D
Complies with IPC-J-001D
Via 3.5 mm pawl socket on back of
device (8).