Installing The Cooktop - GE CP650 Instrucciones De Instalación

INSTALLINg THE COOKTOP

1 INSTALLINg THE JUNCTION BOX
Install an approved junction box where it will be
easily reached through the front of the cabinet
where the cooktop will be located. The cooktop
conduit is 4 feet long.
Install junction box so
that it can be reached
through the front of the
cabinet.
IMPORTANT:
located where it will allow considerable slack in
the conduit for serviceability.
2 PROTECT SURfACE Of COOKTOP
Place a towel or tablecloth onto the countertop.
Lay the cooktop upside down onto the protected
surface.
Bottom of cooktop
Cloth under Cooktop
Installation Instructions
16"
Min.
The junction box must be
3 ATTACH fOAM TAPE
Apply the foam tape around the outer edge of the
glass. Do not overlap the foam tape.
Bottom of Cooktop
Cooktop
Glass
Note: On CP650S, PP962S, PP972S, PP975S
& PP980S models, apply the foam tape around the
outer edge of the glass on the sides and rear of
the unit only.
4 LOCATE MOUNTINg PARTS
Remove the Hold Down Brackets and screws from
the literature package.
Mounting Screw
5 ATTACH BRACKETS TO COOKTOP
Screw the Hold Down Bracket to the side
of the cooktop unit. Repeat for opposite side of
cooktop.
Bottom of Cooktop
Cooktop Glass
5
Foam Tape
Pre-Drilled Hole
Foam Tape
Hold Down
Bracket