Honeywell Home RDWL313A2000 Guía De Instalación Y Operación página 4

Install Doorbell
If you are not mounting the doorbell to the wall, place it where you want it.
1. Mount the screw on to the wall using the
supplied anchor if necessary. Leave 2 mm
of the screw sticking out from the wall.
Drill 1/4 inch holes for the anchor.
Install Push Button
1. Mount the push button
bracket in the desired
location.
Use the screws
–OR–
Use the adhesive backing. If
using the adhesive backing,
clean the surface first.
2. Snap the push button onto
the mounting bracket.
Note: If you need to remove the push button, use a small
screwdriver to release the tab.
2. Hang the doorbell on the
screw.
–OR–
4