Akai Professional MAX25 Guia Del Usuario página 15

Mackie Control & HUI Protocols
MAX25 can use the Mackie Control or HUI (Human User Interface) protocols to control certain functions in
DAWs that support them. MAX25 has Mackie Control and HUI Programs in its internal memory precisely for
this purpose.
To select/load the Mackie Control or HUI Program:
1. Press [PROGRAM]. (Each time MAX25 is first
powered on, it will automatically be in Program
Mode.) The LCD will show the current Program
name (flashing).
2. Turn the VALUE DIAL to browse through the list
of available Programs.
3. Press the VALUE DIAL to load the desired
Program: Mackie Control or HUI.
IMPORTANT:
• Your DAW must also be set to receive commands from an external device (i.e., MAX25) using the
Mackie Control or HUI protocol.
• If you are using Pro Tools, select the Pro Tools Program.
• If you are using Pro Tools Express, select the PTEX Program.
Arpeggiator
To activate the Arpeggiator:
1. Make sure [ARP MODE] is lit. If it is unlit, press it.
2. Press [ON/OFF] (next to the pads).
3. Play some chords on the keyboard!
Latching the Arpeggiator:
When the Arpeggiator is on and [LATCH] has been enabled, you can hold down a combination of keys, and
the Arpeggiator will memorize and continue to arpeggiate these notes, even after you lift your fingers. There
are a couple of ways to use the [LATCH] function:
a. While holding down the keys, you can add more notes to the arpeggiated chord by pressing down
additional keys.
b. If you press the keys, release them, and then press down a new combination of notes, the Arpeggiator
will memorize and arpeggiate the new notes.
Arpeggiator settings:
You can set the Arpeggiator's settings by using MAX25's pads. Each pad has text printed above it on the
right-hand side, which denotes an Arpeggiator mode.
To adjust the Arpeggiator's octave range (up to three octaves), hold down [ARP MODE] and use the
OCTAVE UP/DOWN buttons.
Hold down [ARP MODE] and the currently selected pads will illuminate red to show the Arpeggiator's current
settings:
• The available Arpeggiation types are:
o Up: Notes will sound from the lowest to the highest.
o Down: Notes will sound from the highest to lowest.
o Incl (Inclusive): Notes will sound from the lowest to the highest, then back down. The lowest and
highest notes will sound twice at the direction change.
o Excl (Exclusive): Notes will sound from the lowest to the highest, then back down. The lowest
and highest notes will sound only once at the direction change.
o Random: Notes will sound in random order.
o Chord: All notes of the chord will sound together repeatedly
o Note Double: Each note will sound twice. This setting can be selected in conjunction with any of
the settings described below, except Chord.
o Pattern: Determines whether the Arpeggiator will use the pattern shown in the Pattern Indicator
or not. See the Arpeggiator part of the Edit Mode section for more information.
You can adjust more Arpeggiator settings (Gate, Swing, Pattern, etc.) in Edit Mode. See the Arpeggiator
part of the Edit Mode section for more information.
Note: As a shortcut, you can hold [SHIFT]
then press one of the following buttons to
access certain Programs:
• [PROGRAM] = the last used Program
• [MACKIE CONTROL] = Mackie Control
protocol
• [HUI] = HUI control protocol
15