Step 8 Assemble Dome; Step 9 Attach Dome To Emitter - Endless Summer 233000 Manual Del Usuario

Contact 1-800-762-1142 for assistance.
Do not return to place of purchase.
Step 8 – Assemble dome
Note: Each dome section has a pin mounted in place in the rolled bottom
edge. If necessary for proper alignment of dome sections, loosen each
screw prior to further assembly and retighten after sections are aligned.
• With the large side facing up, slide a dome rib on to the same side
of one dome section as the pin. Slide two dome sections together,
allowing the exposed end of the pin slide into the rolled edge of the
next dome section. Line up hole in dome with threaded hole in pin.
• Insert one Dome Screw and secure loosely.
• Repeat procedure to complete the assembly of all three sections.
• Slide Dome bolt through bottom check plate (with small center hump),
being sure that the rolled edge faces down.
• Slide bolt from previous step through the center of the assembled
dome sections, and be sure that the rolled edge of the check plate fits
inside of the ends of the three Dome Ribs. Also be sure that the slots
in the check plate line up with the holes on the dome sections.
• Slide the other check plate over the Center bolt with the rolled edge
facing up, again making sure that the plate fits inside of the Ribs and
the holes line up with those in the dome.
• Spin the medium nut all the way down the bolt, clamping all of the
pieces in place, making sure that all of the humps fit inside one
another.
• Fully tighten all of the screws in the rolled edge.
• Slide Dome Cap over Dome Bolt, lining up notches in cap with Dome
Ribs. Thread on finial until tight.
Step 9 – Attach Dome to Emitter
Gently lay heater on its side using one styrofoam end to prop up
top half.
Align holes in Dome with threaded studs in Emitter brackets.
Secure Dome to Emitter using (3) Cap Nuts.
Leave Heater on its side for next step.
Owner's manual: model 233000 outdoor patio heater 7/13/04
NOTE:
The white ceramic cone in the top of
the engine is an important piece.
DO NOT REMOVE.
®
10