Power Linking; Fuse Replacement; Mounting Diagram - Chauvet DJ Intimidator Scan 110 Guía De Referencia Rápida

AC Power
This product has an auto-ranging power supply that works with an input voltage range of 100 to 240 VAC, 50/60 Hz.
To eliminate wear and improve its lifespan, during periods of non-use completely disconnect the
product from power via breaker or by unplugging it.

Power Linking

For the maximum number of Intimidator Scan 110 products that you can power link at each voltage, see the User Manual
or the sticker on the product.

Fuse Replacement

1. Disconnect the product from power.
2. Wedge the tip of a flat-head screwdriver into the slot of the fuse holder.
3. Pry the safety cap out of the housing.
4. Remove the blown fuse from the clip on the front of the safety cap and replace with a fuse of the exact same
type and rating.
5. Re-insert the fuse holder and reconnect power.
Mounting
Before mounting this product, read the

Mounting Diagram

Safety Cable
(such as CH-05 from
Chauvet)
Safety Cable
Pass-through
Intimidator Scan 110 QRG Rev. 2
QUICK REFERENCE GUIDE
Safety Notes.
Mounting Clamp
(such as CLP-10 from Chauvet)
Mounting Bracket
Feet for Floor Mounting (x4)
EN
2