Velleman CAMTVI12 Manual Del Usuario página 7

5. Installation
1. Slightly loosen the hex screw on the bracket.
2. Choose your mounting spot. Take the base as a template and drill the
necessary mounting holes. If necessary, drill a hole for routing the
cables. Insert a nylon plug in each hole.
3. Pass the camera cable through the base and fix the bracket using the
included screws. If applicable, pass the cable through the routing hole.
4. Slightly loosen the hex screw, adjust the camera lens and aim it
toward the surveillance area.
5. Tighten the hex screws. Connect and power your camera (see below).
Check the viewing angle on your PC.
V. 01 – 20/12/2016
CAMTVI12/CAMTVI12G
7 ©Velleman nv