Airone ELEKTRA INOX 90 Instrucciones Para El Uso, Mantenimiento E Instalacion página 11

INSTALLATION AND ASSEMBLY INSTRUCTIONS
The suction of the downdrafts, regarding the traditional hoods, is penalized in the suction of the cooking vapors of the
front pots. For this reason the use of a panoramic glass ceramic top is suggested.
The hood can be combined with gas hob with maximum total power of back heaters equal to 4.7 Kw.
Warning: We decline all responsibility for damages to hoods with gas installations with higher powers.
Once the installation is complete, the electrical components (cables, connectors, motor and control box) will no
longer be accessible to the user. To allow access to those parts place a removable panel secured with screws.
The downdraft can be used for both filtering and suction. When the filtering function is operating, with air recycle,
carbon filters must be used. When the downdraft is used in the filtering function, there must be a suitable section for
spillage of the air suction on the base of the kitchen.
When the suction function is operating, exhausting the filtered air on the outside, a suitable compensation system
must be used according to current standards in force. The diameter of the fume exhaust pipe must be the same or
greater than the diameter of the downdraft pipe union.
There must be sufficient ventilation in the room where the downdraft is installed, to allow the simultaneous use of
other appliances that use gas or other fuels.
Make a hole in the downdraft approximately 50mm from the work top hole.
For the dimensions of the hole, see drawing here below.
The hood is supplied with a side hinged cover support. The cover is available in steel (supplied with the stainless steel
downdraft models), in glass (supplied with the glass downdraft models) or in the same material used for the kitchen
tops (not supplied, MAX 7Kg).
The gluing of the cover of the downdraft, must be performed in the same place after finishing the assembly of the
downdraft.
The model and technical data labels can be
attached to the cover on the downdraft unit and
behind the metal filters.
Caution: In the kitchen furniture, provide in
front or behind of the downdraft a removable
wall to allow technicians to remove the front or
rear panel of the hood in case of assistance.
The assistance must be performed by
authorized specialists. Failure to comply with
this condition, significant increased costs could
be charged in the case of assistance.
EN -8