ACDelco ARI1265 Manual De Instrucciones página 9

INSTALLING OR REMOVING BATTERY PACK
TO REMOVE BATTERY PACK: Depress the battery pack release button (9) and pull
the battery pack (10) out of tool.
TO INSTALL BATTERY PACK: Push the battery pack (10) onto tool until it locks in
place.
INSTALLING BITS
Always follow the procedure below to install a driver bit:
1. Pull the guide sleeve (3) forward.
2. Insert the bit into the hexagonal hole.
3. By releasing the guide sleeve it will return to its original position.
REMOVING BITS
Always follow the procedure below to remove a driver bit:
1. Pull the guide sleeve (3) forward.
2. Take the bit out from the hexagonal hole.
3. By releasing the guide sleeve it will return to its original position.
CAUTION
1English1
ASSEMBLY
Always set switch (7) to off position when installing and
removing bit.
English -8