Cleaning And Maintenance - Mx Onda MX-AS2058 Manual De Instrucciones

USE OF HAND VACUUM CLEANER
This vacuum cleaner can be used as a handheld vacuum cleaner. In such a
case it is not necessary to use any accessory since a folding brush is located
on the main body of the vacuum cleaner. Or if you wish you can use the double
nozzle (fine + brush) to access the gaps or poorly accessible sites.
Switching the vacuum on and off
To turn on the vacuum press the on / off switch B. Once the use is finished,
press the on / off switch B to turn off the vacuum. Then unplug the power cord.

CLEANING AND MAINTENANCE

To obtain the best results during the cleaning process it will always be
necessary that both the tank and all the filters are perfectly clean. If you
proceed to the work of using the vacuum cleaner and these elements are dirty,
the suction power will decrease considerably. Never operate the vacuum
cleaner without all filters being correctly positioned and completely clean,
otherwise dirt particles can penetrate inside the vacuum cleaner causing
engine damage.
Attention: Before cleaning or manipulating the vacuum cleaner, make sure
it is unplugged from the mains.
Dust cleaning
Unplug the vacuum from the mains.
Hold the tank and press the tank eject button C (Fig. 1).
Press the opening clip of the tank lid and empty the tank.
Once the tank has been emptied, remove the cyclone filter by pulling it
outwards, as follows:
Folding brush
9