Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION
All wiring must conform to local and national electrical codes and ordinances.
Connect in accordance with wiring diagrams provided by the equipment manufacturer. If none are provided,
the following represents a typical installation.
SIngle Element Circuit for Full
Power Disconnect Through
Both Power Conductors
SETTING THE DIAL
Adjust temperature setting by inserting a screwdriver into
open slot and turning pointer to desired temperature on
dial.
Wiring
L1
L2
1
2
Factory
Installed
1
Jumper
2
Heating Element
150°F
66°C
3
4
Adjustment Slot
90°F
32°C
125°F/52°C
Publicidad
