Firmware Version; Replacing The Fuse - Beamz LCB144 LED Colour Bar Manual De Instrucciones

DMX CHANNEL MODE
You can control the fixture in two modes:

3 channel mode

5 channel mode

6 channel mode

12 channel mode

24 channel mode

48 channel mode
To adjust the setting:
1. Select "CHNd" MODE and press "ENTER". The currently set option will blink in the display.
2. Use the "DOWN" and "UP" buttons to select 3ch, 5ch, 6ch, 12ch, 24ch or 48ch.
3. Press "ENTER" to save your selection.
BEHAVIOR WITHOUT DMX (DMX STATE)
The DMX STATE setting determines how the fixture behaves when it is not receiving a DMX signal. You can set the fixture to
enter Auto Mode, Sound Mode or black out.
To adjust the setting:
Select "SLNd" and press "ENTER". You can choose between "Mast", "SL1", "SL2" and "d512". For use the Auto or sound the
fixture must be set on "Mast". When is select "SL1", "SL2" or "d512" the fixture is black when without DMX.
2. Use the "Down" or UP buttons to select "Auto" or "Sound" and press "ENTER".
3. When "Auto" you can choose between 16 auto programs select your program with de "Down" and "UP" buttons and press
"ENTER".
When "ShNd" (sound programs) you can choose between 16 sound programs select you program with de "Down" and "UP"
buttons and press "ENTER".

FIRMWARE VERSION

To display the fixture's current firmware version, select "UER" and press ENTER. The display will show the version of firmware
in the fixture. Press MENU to exit.
IR MODE
Press mode key until Iron or IroF is displayed; then press Up or Down button to
choose Iron. Press ENTER to confirm.
To switch off the lights:
Press OFF on the remote control. All the lights will turn off until the button ON is
pressed [1].
Manual colour control
You can set R/G/B/W colours with the remote by pushing either the Red <R> button
for red, the Green <G> button for green, the Blue <B> button for blue [3].
Each colour intensity is then adjustable using the Light Up and Down [2] buttons
Preset colour mode:
Press one of the twelve preset colours on the remote control [4]. No dimming
possible with preset colours.
AUTO/SOUND on the IRC.
Press one of the four buttons to choose between the different auto programs. [5]

REPLACING THE FUSE

If the fuse is defective, replace the fuse with a fuse of the same type and value. Before replacing the fuse, unplug mains lead.
Procedure:
Step 1: Open the fuse holder on the rear panel with a fitting screwdriver.
Step 2: Remove the old fuse from the fuse holder.
Step 3: Install the new fuse in the fuse holder.
Step 4: Replace the fuse holder in the housing.
5