Front And Rear Panel - Beamz professional Phantom Serie Manual De Instrucciones

BEAM PROTECTION
For safety reason you can switch the One Beam protection On/Off via display. If the One Beam is activated (ON) highly focused
single beam are suppressed. Switch to OFF to deactivate the One Beam protection.
This function should only be turned off by well-trained operator, after checking well all safety aspects!
ILDA CONTROL
This laser can be controlled by any PC equipped with ILDA compatible software + hardware. As soon as the ILDA input of the
laser is connected with an ILDA compatible controller, it will automatically switch to ILDA control mode. From this moment on
the laser will be completely controlled by the ILDA software: the possibilities of the ILDA software will determine what you can
do or not.
ILDA soft- and hardware are available from several independent suppliers. Some possible choices are:
- PANGOLIN software (www.pangolin.com)
- And many other, up to you and your finances to see what is best for your needs.

FRONT AND REAR PANEL

1. Laser Aperture
2. Laser Emission LED
3. DB25 ILDA interface
4. LCD Function setting panel
5. RED brightness knob
6. X invert
7. Y invert
8. Sound sensitivity knob
9. Interlock (Laser output is available only
when the interlock is connected.)
10. DMX in/out
11. Fuse
12. Key switch
13. Power LEDs indicator
14. Blue brightness knob
15. Sound active microphone
16. Green brightness knob
17. On/Off switch
18. Power in/output