Trouble-Shooting; Fault Condition - GLW MC25 Manual De Instrucciones

TROUBLE-SHOOTING

Fault condition 1

Cable cannot be inserted.
Cable can only be inserted in start position (front)
and not in maintenance position (rear).
Press the reverse button (1) to move the mc 25
into start position.
Fault condition 2
Crimping has not been completed.
Disconnect the mains supply from the
mc 25 and open cover.
1. Stop operation
 Read counter (1) if required.
 Turn off (position 0) the mc 25 with mains
switch (2).
 Disconnect mains cable (3).
10/12
Diagram 19 Move the mc 25 into start
position
Diagram 20 Stop operation
17