Changing Drive Function; Changing Adjusting Function - Vermeiren LiNX 200 Manual De Instrucciones

Changing drive function

Changing adjusting function

The selected adjusting function is displayed on the drive/actuator status indicator as shown below.
The display shown only the available/programmed functions in your wheelchair.
Adjust function
Seat inclination
Lift
Leg rest right
Unspecified
The wheelchair's drive function can be selected with
the drive function select button, which is located below
the power button on the left-hand side of the remote
module.
Press the top of the button to select the next drive
function. Press the bottom of the button to select the
previous drive function.
The drive function selected is indicated on the drive
function indicator, which is located to the right-hand
side of the drive select button.
The indicator has three LED's:
1. when drive function 1 is selected, the bottom
indicator will be lit;
2. when drive function 2 is selected, the bottom and
middle indicators will be lit;
3. when drive function 3 is selected, all indicators will
be lit;
The wheelchair's adjusting functions can be selected
with the adjusting function select button, which is the
rocker button located on the right-hand side of the
operator control.
Press the top of the button to select the next adjusting
function. Press the bottom of the button to select the
previous adjusting function. Note that only adjusting
functions that have been programmed will be
available for selection.
Display Adjust function
Backrest inclination
Leg rest left
Leg rests simultaneous
6
Display
None
LiNX 200
vA - 2016-09