Legal Notices - Insignia NS-LCD26-09 Guia Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Component
Y:1 V(p-p), 75 ohm, including sync
input
Pr/Cr:±0.35 V(p-p), 75 ohm
Pb/Cb:±0.35 V(p-p), 75 ohm
Audio:500 mV(rms)
Suggested resolutions:1080i, 720p, 480p, 480i
HDMI input
2 HDMI input terminals
HDCP compliant
E-EDID compliant
Suggested scan rates:1080i, 720p, 480p, 480i
VGA input
D-Sub 15-pin terminal
E-EDID compliant
Suggested scan rates:640×480 /60 Hz,
800×600 /60 Hz, 1024×768 /60 Hz,
1360×768 /60 Hz
Audio input: Headphone mini-jack for stereo
Dimensions
25.67 × 18.89 × 8.66 inches
(with base)
(65.2 × 48.0 × 22.0 cm)
Weight
19.4 lbs. (8.8 kg)
Accessories
Power cord
User guide
Remote control
Batteries (2 AAA)
VGA cable
PC audio cable
14

Legal notices

FCC Part 15
This device complies with Part 15 of the FCC Rules.
Operation of this product is subject to the following two
conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any
interference received, including interference that may cause
undesired operation.
This equipment has been tested and found to comply within
the limits for a class B digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and
can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no
guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more
of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and
• Connect the equipment into an outlet on a circuit
• Consult the dealer or an experienced technician for
FCC warning
Changes or modifications not expressly approved by the
party responsible for compliance with the FCC Rules could
void the user's authority to operate this equipment.
Cables
Connections to this device must be made with shielded
cables with metallic RF/EMI connector hoods to maintain
compliance with FCC Rules and Regulations.
Manufactured under license from Dolby Laboratories. "Dolby" and
the double-D symbol are trademarks of Dolby Laboratories.
www.insignia-products.com
Insignia NS-LCD26-09 26" LCDTV
receiver.
different from that to which the receiver is connected.
help.

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido