LG WM2277H Serie Manual Del Propietário página 22

TROUBLESHOOTING GUIDE
Problem
2 2
Possible Cause
• Water supply is not adequate
in area.
• Water supply taps are not
completely open.
• Water inlet hose is bent.
• The filter of the inlet hose
clogged.
• Drain hose is bent
or clogged.
• The drain filter is clogged.
• Load is too small.
• Load is out of balance.
• The appliance has an imbalance
detection and correction system.
If individual heavy articles are
loaded (bath mat, bath robe,
etc.) and the imbalance is too
great, after several attempts to
restart the spin cycle the
machine will stop and the error
code will be displayed.
• Is the door opened or not
completely closed?
• The water overfills due to the
faulty water valve.
• The water level sensor
malfunction.
• Overload in motor.
• Overload in motor.
• The washer experienced a
power failure.
Solution
Check another tap in the house.
Fully open tap.
Straighten hose.
Check the filter of the inlet hose.
Clean and straighten the drain hose.
Clean the drain filter.
Add 1 or 2 similar items to help
balance the load.
Rearrange load to allow proper
spinning.
Close the door completely.
If is not released, call for service.
Unplug the power plug and call for service.
Close the water tap.
Unplug the power plug.
Call for service.
Restart the cycle.