Setup - John Bunn Neb-u-Tyke Penguin Manual De Instrucciones

SETUP

Note: Before initial operation, clean the nebulizer cup as-
sembly following the instructions given in MAINTENANCE/
Cleaning the Nebulizer Cup.
WARNING: Ensure that the nebulizer compressor is un-
plugged during setup.
1. Before each use, inspect the compressor and nebulizer
cup assembly for damage or wear; replace as needed.
2. Place the compressor on a table or other flat stable sur-
face (not on the floor), in an area that is clean and dust-
free. Be sure you can easily reach the controls when
seated.
3. Open the nebulizer medication cup: Twist the cap coun-
ter-clockwise until it stops, then lift cap off.
4. Use a medicine dropper or pre-
measured dose to add the pre-
scribed amount of medication to
the nebulizer medication cup.
Caution: Do not fill the medica-
tion cup with more than 10 ml of
medication per treatment.
DO NOT OVERFILL.
5. Install cap on cup. Turn clockwise
to tighten.
6. If using the mouthpiece for treat-
ment, proceed to step 7. If using
a mask, install the bottom part
of the mask directly onto the top
of the nebulizer medication cup
cap as shown at right. Proceed to
step 9.
John Bunn Neb-u-Tyke Penguin Nebulizer Compressor
dropper
cup
add
medication
install cap
on cup
mask
cap
install mask
on cap
cap
cup
7