Safety Overload - John Bunn Neb-u-Tyke Penguin Manual De Instrucciones

4. Place the nebulizer mouth-
piece between teeth and
close mouth (or install
mask on face).
5. As aerosol starts flowing,
inhale deeply and slowly
through mouthpiece (or
mask).
WARNING: Never use a nebulizer with a clogged nozzle.
If the nozzle is clogged, the aerosol mist will be reduced,
altered or stopped, which will diminish or eliminate the
effectiveness of the treatment. If clogging occurs, replace
the nebulizer.
Note If you need to interrupt treatment, move the ON/OFF
switch to the OFF position.
6. When the treatment is complete, move the ON/OFF
switch to the OFF position to turn off the compressor.
7. Unplug the compressor from power outlet.
8. Disconnect nebulizer from tubing.
9. Clean nebulizer as instructed in MAINTENANCE/Clean-
ing the Nebulizer Cup.

Safety Overload

Note: Do not exceed 30 minutes of continuous operation.
1. The motor of this device has a built-in thermal overload
protector. Should the motor overheat, the protector
will automatically shut off the motor. Should this occur,
move the ON/OFF switch to the OFF position and allow
the motor to cool down for approximately 30 minutes
before turning it on again.
2. If the overload protector shuts off the motor frequently,
you may have an unstable voltage situation.
3. If the device shuts down and cannot restart, it may need
to be replaced. Call your Graham-Field distributor imme-
diately.
John Bunn Neb-u-Tyke Penguin Nebulizer Compressor
mouthpiece
inhale through
mouthpiece
9