BOMANN BQ 2243 CB Instrucciones De Servicio página 27

Installation
Please refer to the illustrations.
1. Remove the parts from the packaging.
2. Clean the grid and grill pan with a damp cloth.
3. Pour 1 liter of cold water into the grill pan up to the "MAX" mark. A
"MAX" mark can be found on the back section of the grill pan.
CAUTION:
Always grill with water to avoid overheating.
Do not fill with water above the "MAX" mark in order not the
damage the heating element.
4. Fit the heating element with the thermostat onto the housing.
Slide the thermostat from above into the recess of the housing.
Press gently until it audibly clicks into place.
5. If required, fit the windshield.
NOTE:
The thermostat is equipped with a safety switch. It prevents
operation of the heating element outside the housing.
Check that the thermostat is properly fitted in the housing.
Electric installation
1. Be sure the voltage of the device (rating plate) is in accordance
with the mains voltage.
2. Connect the mains plug to a properly installed shockproof socket
only.
Connected load
The device is intended for a maximum power intake of 2000 W. This
connected load recommends a separate input lead secured with a
16 amp protected switch.
CAUTION Overload:
• When using extension cords, these should have a cable cross-
section of at least 1.5 mm².
• Do not use gang plugs, because the device is too powerful.
Prior first-time operation
• Operate the device without barbecue for 15 minutes whilst grill
base is filled with water.
WARNING:
• Always unplug the device and allow the device to cool down before cleaning.
• Do not under any circumstances immerse the heating element into water for cleaning.
Danger of electric shock or fire.
• Turn the temperature control on the thermostat to the highest
position.
• The protective foil on the heating element will be removed.
NOTE:
Slight formation of smoke is thereby normal. Ensure sufficient
ventilation.
Your appliance is now ready for use.
Operating your device
CAUTION:
The appliance must always rest on a horizontal, stable, and heat
resistant surface during use.
1. Pour 1 liter of cold water into the grill pan up to the "MAX" mark.
2. Preheat the operable device for about 5 minutes prior use.
3. Set the temperature control according to the intended use:
Low or middle settings for keeping warm or cooking, highest
setting for fast cooking or barbecuing. The indicator light indicates
the operation of the heating.
4. Place your grill items directly on the grid. Turn the barbecue from
time to time.
CAUTION:
Check the water level!
After grilling for a long period, the water must be replenished.
First disconnect from the mains and then fill with water up to the
"MAX" mark.
Do not pour cold water over the hot heating element.
It might get damaged.
Switching off
Turn the temperature control anti-clockwise as far as it will go and
unplug the device.
The thermostat is equipped with a safety switch. It prevents operation
of the heating element outside the housing.
If the heater cannot be switched on, check the mains outlet and that
the thermostat has been correctly fitted into the housing.
Cleaning
Troubleshooting
27