ESX Q-FOUR Manual De Uso página 13

ENG
4-CHANNEL OPERATION STEREO (FIG. 3)
If you want to run the amplifier with 4 line output channels from the headunit to drive 4 loudspeakers,
in stereo connect the following setup:
(1) RCA audio signal input from the headunit, CH1 / FRONT LEFT
(2) RCA audio signal input from the headunit, CH2 / FRONT RIGHT
(3) RCA audio signal input from the headunit, CH3 / REAR LEFT
(4) RCA audio signal input from the headunit, CH4 / REAR RIGHT
(5) Stereo high level input for loudspeaker outputs from the headunit FRONT L/R
(6) Stereo high level input for loudspeaker outputs from the headunit REAR L/R
(7) Loudspeaker CH1 / FRONT LEFT (2 - 8 Ohms)
(8) Loudspeaker CH2 / FRONT RIGHT (2 - 8 Ohms)
(9) Loudspeaker CH3 / REAR LEFT (2 - 8 Ohms)
(10) Loudspeaker CH4 / REAR RIGHT (2 - 8 Ohms)
NOTE: (1 – 4) must not be operated simultaneously with (5 & 6).
3-CHANNEL OPERATION STEREO/MONO (FIG. 4)
If you want to run the amplifier with 4 line output channels from the headunit to drive 2 loudspeakers
in stereo and a subwoofer, connect the following setup:
(1) RCA audio signal input from the headunit, CH1 / FRONT LEFT
(2) RCA audio signal input from the headunit, CH2 / FRONT RIGHT
(3) RCA audio signal input from the headunit, CH3 / REAR LEFT or SUB OUT
(4) RCA audio signal input from the headunit, CH4 / REAR RIGHT or SUB OUT
(5) Stereo high level input for loudspeaker outputs from the headunit FRONT L/R
(6) Stereo high level input for loudspeaker outputs from the headunit REAR L/R
(7) Loudspeaker CH1 / FRONT LEFT (2 - 8 Ohms)
(8) Loudspeaker CH2 / FRONT RIGHT (2 - 8 Ohms)
(9) Subwoofer CH3/4 (4 - 8 Ohms)
NOTE: (1 – 4) must not be operated simultaneously with (5 & 6).
2-CHANNEL OPERATION MONO (FIG. 5)
If you want to run the amplifier with 2 line output channels from the headunit to drive 2 subwoofers in
mono, connect the following setup:
(1) RCA audio signal input from the headunit, CH1 / FRONT LEFT or SUB OUT 1
(2) RCA audio signal input from the headunit, CH2 / FRONT RIGHT or SUB OUT 2
(3) RCA audio signal input from the headunit, CH3 / REAR LEFT or SUB OUT 1
(4) RCA audio signal input from the headunit, CH4 / REAR RIGHT or SUB OUT 2
NOTE: Split the subwoofer signal coming from the headunit by using two Y-connectors, to supply a
audio signal to the connections (1 - 4).
(5) Stereo high level input for loudspeaker outputs from the headunit FRONT L/R
(6) Stereo high level input for loudspeaker outputs from the headunit REAR L/R
(7) Subwoofer 1 CH1/2 (4 - 8 Ohms)
(8) Subwoofer 2 CH3/4 (4 - 8 Ohms)
NOTE: (1 – 4) must not be operated simultaneously with (5 & 6).
13