Using The Appliance; Maintenance And Cleaning; Technical Data - ECG RK 1520 Glass Manual De Instrucciones

lid, the outer surfaces are hot. Do not use the appliance close to objects
which can be damaged by steam.
WARNING
1. Always use cold water when filling the kettle.
2. The water level must be between the MAX. and MIN. levels!
Hot water may spurt out if the kettle is overfilled.
3. Switch off the kettle before removing it from the base.
4. Always make sure the lid is well closed.
5. The base and kettle body should not be wet.
6. Only use the kettle in combination with its original base.
You may not use the kettle to heat any other liquids than water. Never put in the kettle tea bags, loose
tea or any other ingredients for making beverages!

USING THE APPLIANCE

Remove and wash them before first use with an ordinary detergent used for washing dishes. Then rinse with
lukewarm water.
Fill the kettle with clean, cold and potable water up to max. level before first use, switch it on and bring the
water to a boil. Then pour the water out and repeat the procedure at least five times. With this procedure you
will properly clean the kettle and remove any possible bad taste. If you have the impression that you bad taste
from the boiled water, we recommend to repeat the procedure. It is also recommended the leave the empty
kettle open for 24 hours. The kettle material coming into contact with water is certified as harmless to health.
Any slight "smell" or "bad taste" during initial use after unpacking kettle is a normal phenomenon and should
not be cause for return of the appliance.
1. Fill the kettle with water. Do not overfill the kettle, watch the water level indicator.
2. Place the kettle on its base.
3. Switch the appliance on by sliding the switch to position "1" after putting the plug into the outlet. Lit
indicator signals the heating of water.
4. The kettle will switch off automatically after the boiling process has finished.
5. Unplug the cord from the outlet.
6. Do not open the lid when pouring the water out.

MAINTENANCE AND CLEANING

Always unplug the cord from the outlet before cleaning!
Wipe the outside of the appliance with a moist cloth and then wipe dry.
The scale filter can be removed for the cleaning process. Use designated and commonly available agents to
remove scale from the kettle.

TECHNICAL DATA

1.5 l capacity
Nominal voltage: 220–240 V~ 50/60 Hz
Nominal input power: 1850–2200 W
Do not immerse in water!
GB
25