Working With Core Drills - MAGLOGIX MagnaDrill MXD-2.0 Manual De Instrucciones

Taladro magnético
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Working with Core Drills

 Push the ejector pin (centring pin) through the core drill head.
 Core drills with Weldon shank are tightened with clamping screws (DIN 913) on both clamping surfaces.
Risk of injury! Always wear gloves since the edges are sharp.
 Set the core drill on the workpiece and start drilling until the whole cutting area is marked as a circular ring.
 The core drill should be cooled constantly during the drilling process. Optimum cooling is possible through our
coolant equipment using inner cooling.
 Do not switch the drive motor off during drilling, and after the drilling process pull the core drill back with the
motor still running.
 Remove swarf and core after every drilling process.
Use a swarf key to remove the swarf. Do not touch with your bare hands. Risk of injury!
9

Publicidad

Tabla de contenido
loading

Tabla de contenido