Kenwood LS-X70 Manual De Instrucciones página 4

Connections
This speaker system adopts the bi-wiring connection. Read "Bi-wiring Connection" on page 5 for details.
Note on connection
1. Be sure to turn off your amplifier before connecting or disconnecting speakers.
2. This speaker system has a nominal impedance of 8 ohms. To ensure safe and reliable operation, be sure that your
amplifier or receiver (audio video control center) is able to work with 8-ohm speaker.
• Never short the (+) and (–) speaker wire's conductors together.
• Do not reverse L and R or (+) and (–) connections. Reversal of sides or polarities may result in unnatural, incorrectly positioned
sound.
Note on operation
The speaker system's peak input power is indicated in the specifications. To avoid speaker damage, never run the speak-
ers at power levels exceeding this limit.
7 Standard connection
1 Connect the speaker wire to the input terminals of the speaker.
· ª
2 Lay the speaker wire.
To prevent the speaker from toppling down, the speaker should be placed on its side before connection. Lay the speaker
gently and pass the speaker wire through the hole on the base.
Base
Insert the speaker wire here.
4
EN
1Loosen
2 Insert the conductor
3 Secure
Wire with white line
1
The speaker wire can also be connected to the speaker by
using banana plugs which are commercially available in
audio stores.
To use the banana plug connection, tighten the screws on
the speaker terminals before inserting the banana plug.
• According to the speaker layout, pass the speaker wire un-
der one of notches A, B and C on the base.
2
Notches for
speaker wire