Technical Data - Cibo Finit-All SMFA 2018 Manual De Instrucciones

EN
2002/96/EC relating to electrical and electronic
waste and implementation of national law, used
electrical tools must be collected separately and
disposed of in an environmentally friendly
manner at recycling centres.

14. TECHNICAL DATA

Explanatory notes on the specifications on
page 3. Changes due to technological progress
reserved.
Ø = max. diameter of the accessory
t = max. permitted thickness of clamping
max,2
shank on accessory
t = roughing disc/cutting disc:
max,3
max. permitted thickness of accessory
M = spindle thread
l = length of the grinding spindle
n * = no-load speed (adjustable)
v
P = rated input power
1
P = power output
2
m= weight without mains cable
Measured values determined in conformity with
EN 60745.
~ AC power
machine in protection class II
* Energy-rich, high-frequency interference can
cause fluctuations in speed. The fluctuations
disappear, however, as soon as the interference
fades away.
The technical specifications quoted are subject
to tolerances (in compliance with the relevant
valid standards).
34 Ι Finit-All
Emission values
These values make it possible to assess the
emissions from the power tool and to compare
different power tools. The actual load may be
higher or lower depending on the operating
conditions, the condition of the power tool or
the accessories.
Please allow for breaks and periods when the
load is lower for assessment purposes. Arrange
protective measures for the user e.g. organisatio-
nal measures based on the adjusted estimates.
Vibration total value (vector sum of three directi-
ons) determined in accordance with EN 60745:
a = Vibration emission value
h, SG
(surface grinding)
a = Vibration emission value
h, DS
(sanding with sanding plate)
K = Uncertainty (vibration)
h, SG/DS
Typical A-effective perceived sound
L = sound-pressure level
pA
L = acoustic power
WA
K , K = Uncertainty
pA WA
Manual
Finit-All