Technical Data; Installation Instructions - Climadiff CLE18 Manual De Utilización

Ocultar thumbs Ver también para CLE18:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

3. TECHNICAL DATA

Below is an example of the nameplate:
The nameplate attached to the inside or rear of the appliance (depending on the model) includes the
entire information specific to your appliance.
We recommend that you make a note of its serial number in this booklet prior to installation, so that you
can refer to it later (technical work, request for assistance, etc.).
Once the appliance is installed and loaded, access to it is not so easy.
CAUTION: no assistance can be provided without this information.

4. INSTALLATION INSTRUCTIONS

Before using this appliance
 Remove the exterior and interior packing.
 Before connecting the appliance to the power source, let it stand upright for approximately 24 hours.
This will reduce the possibility of a malfunction in the cooling system from handling during
transportation.
 Clean the interior surface with lukewarm water using a soft cloth.
 When disposing your appliance, please choose an authorized disposal site.
 Place your wine cooler on a floor that is strong enough to support it when it is fully loaded. To level
your Wine cooler, adjust the front leveling leg at the bottom of the wine cooler.
 Adequate ventilation is required, do not block the front air outlet.
 Not designed for placement in adage or basement.
 The appliance is for indoor use only.
 This wine cellar is designed for built-under installation.
 Connect the cellar to a single socket, leaving a 30 mm gap between the back of the cellar and the
wall. Be careful to support it, so that your wine cellar is perfectly level (use of a spirit level is
recommended). This will prevent any movement due to instability, causing noise and vibration, and will
39

Publicidad

Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

Cle51

Tabla de contenido