Sears Kenmore 385.12216 Manual De Instrucciones página 72

Cleaning the Shuttle Race
This area must be kept free of dust, lint and occa-
sional tangled thread° Clean the shuttle race area
about every three months°
o Cleaning the shuttle area"
(_ Center pin of the shuttle
(_) Levers
Bobbin case
1. Raise the needle bar to its highest point and
remove the bobbin case,,
2, Push shuttle race levers aside. Lift shuttle race
cover and take shuttle out,,
3,, Clean the shuttle race with a lint brush.
4_ Put a drop of oil on the center pin of the shuttle
and shuttle race, Do not over-oil.
o Replacing shuttle assembly
(_) Shuttle driver
(6_ Shuttle
(_) Pointed hook
(_ Shuttle race cover
(_) (Oil here)
1, Position shuttle race as illustrated so that shuttle
driver is forming harf moon on the left side of the
machine.
2. Hold shuttle by center pin and position shuttle so
as to form a half moon on the right side, The
pointed hook will be on the bottom.
3. Place shuttle race cover into place over shuttle
assembly.
4., Snap the levers back into the original position.
C
®
®
h
64