Bestway FLOWCLEAR 58405 Manuel De Instrucciones página 4

Assembly
(You will need a screwdriver.)
1. Carefully remove all components from the package and check to ensure nothing is
damaged. If equipment is damaged, immediately notify the retailer from where the
equipment was purchased.
2. The sand filter should be placed on solid, level ground, preferably a concrete slab.
Position the sand filter so the Ports and Control Valve are accessible for operation,
servicing and winterizing.
3. The sand filter must be vertically fixed on ground or a certain pedestal made of
wood or concrete before use to prevent the sand filter from accidentally falling.
Fully assembled sand filter will exceed 18kg. The mounting holes should be 8mm
in diameter and spaced 110mm apart. Use two bolts and nuts with a maximum of
8mm in diameter to fasten the sand filter to the pedestal.
Load pool-grade filter sand
NOTE: Use only special pool-grade filter sand, free of all limestone or clay: #20 Silica sand 0.45-0.85mm, approximately
one 25kg bag should suffice. If you do not use the recommended size of filter sand, filtering performance will be reduced
and the sand filter may damaged, thereby voiding the warranty.
NOTE: To avoid damaging the Skimmer when adding sand, pour some water into the Bottom Tank to submerse the
Skimmer on the Hub.
NOTE: SAND NOT INCLUDED.
S-S-005012/21.0x28.5cm/58405/1500gal美规砂滤器说明书 JS-YF-2016-B-08881/英
MAX
MIN
C
C
4
110mm
Ø8mm
C
S-S-005012