Operation...................................................... 3
IMPORTANT: READ ALL INSTRUCTIONS CAREFULLY BEFORE ASSEMBLY, SERVICE OR
USE OF THIS FAN. FAILURE TO COMPLY WITH THESE INSTRUCTIONS COULD RESULT IN
SERIOUS PERSONAL INJURY AND/OR PROPERTY DAMAGE.
THIS IS A FAN - NOT A TOY!
WARNING
TO REDUCE THE RISK OF
PERSONAL INJURY AND ELECTRIC SHOCK,
FAN SHOULD NOT BE PLAYED WITH OR
PLACED WHERE SMALL CHILDREN CAN
REACH IT.
DO NOT MOVE THE FAN
WARNING
WHILE OPERATING! MOVING
FAN DURING OPERATION CAN CAUSE
BLADE DAMAGE.
To guard against electric shock
WARNING
while operating, do not allow fan
to come in contact with other grounded objects
such as pipes, radiators, etc.
Risk of fire, electric shock, or
WARNING
personal injury when performing
service or maintenance. Unplug or disconnect
the fan from the power supply before servicing.
CAUTION Automatically
WARNING
Operated Device - To Reduce
The Risk Of Injury Disconnect From Power
Source Before Servicing.
To Reduce The Risk Of Fire Or
WARNING
Electric Shock, Do Not Use This
Fan With Any Solid-State Speed Control Device.
To Reduce The Risk Of Electric
WARNING
Shock And Injury To Persons, Do
Not Use In A Window.
To Reduce The Risk Of Electric
WARNING
Shock, Do Not Expose To Water
Or Rain. This unit is designed for indoor use
only.
© 2019, Pinnacle Climate Technologies, Inc.
NEVER LEAVE A FAN UNATTENDED WHILE OPERATING
OR WHILE CONNECTED TO A POWER SOURCE
Table of Contents
Exploded View.................................................... 6
Warranty............................................................. 7
Safety Information
WARNING
qualified person(s) in accordance with all
applicable codes and regulations.
WARNING
or disconnection of a safety device, the safety
device is to be reinstalled or remounted as
previously installed before operating this fan.
WARNING
If you have any questions, contact Customer
Service at 800-641-6996.
- Before operating always check fan for loose or
damaged parts. Inspect power cord for damage.
Never use fan without safety guards attached.
- Operate only on 120 volt 60 Hz (cycle) current
with a minimum 15 amp circuit.
- When used with an extension cord, use a UL
listed, 14 AWG cord equipped with a receptacle
to accept the three-prong grounded plug on the
fan's power cord and a 3-prong grounded plug for
the power source. If extension cord is longer than
50 feet, consult with cord manufacturer for proper
cord AWG rating. Always keep power cord and
extension cords away from heat, oil, and sharp
edges. Inspect cords periodically and replace if
damaged.
2
Installation work and electrical
wiring must be done by
When servicing or replacing a
component requires the removal
Use this fan only in the manner
intended by the manufacturer.
High Capacity Barrel Fan User's Manual