Specifications - Dynex DX-BGDTC Guia Del Usuario

24
signal is too weak; as a rule, slower transmission rates are more stable. Experiment with
different connection rates until you find the best one for your environment; note that all
available transmission rates should be acceptable for browsing the Internet. For more
assistance, see your wireless card's literature.
Why are there two wireless utilities in your system tray?
Which one should you use?
There are several features and advantages to using the WNU over the Windows XP Wireless
Zero Configuration utility. We offer a site survey, detailed link information, and adapter
diagnosis, to name a few.
It's essential to know which utility is managing your adapter. We recommend using the WNU.
To use the WNU:
1 Right-click on the network status icon in the system tray and select View Available
Wireless Networks.
2 Click Advanced in the lower left-hand corner of the Available Wireless Networks
window.
3 From the Advanced tab, uncheck Use Windows to configure my wireless
network. After the box is unchecked, click OK to close the window.
You are now using the WNU to configure the card.
The card is not detected by operating system
• The card is not recognized by your desktop computer.
• The New Hardware Wizard does not appear when booting up the computer.
• You receive Microsoft Error Code: 10
• You receive Microsoft Error Code: 0
To correct the problem try moving the card to another PCI slot. See "Installing the wireless
card" on page 9.

Specifications

Host Interface
Power Consumption
Operating Temperature
Storage Temperature
Humidity
Typical Operating Range
32-bit PCI interface
Tx/Rx peak 510/250 mA @ 3.3 VDC (max.)
32 to 140 degrees F (0 to 60 degrees C)
-4 to 176 degrees F (-20 to 80 degrees C)
Max. 90% (non-condensing)
100 to 200 ft. (30-60 m) indoors
Specifications