Unpacking Laundry Center - Kenmore A03355201A Instrucciones De Instalación

Unpacking Instructions
1. If foam tub block has been removed, reinsert it now
and retape the lid securely.
2. Carefully cut the front and back corners of the left
side of the remaining cardboard.
3. With help from a second person, carefully tip the
laundry center slightly to the left as shown in the
picture below. First remove the foam shipping support
to the right side only and then remove the foam base.
Save these items for future use.
1
Pull out
RIGHT side
ONLY!
2
3

Unpacking Laundry Center

4. Carefully lower the laundry center to an upright
position and remove the tape holding the lid shut.
Remove the foam tub block and other tub contents.
NOTE
If the laundry center is to be transported at a later date,
the tub blocking pad, foam base and tub support should
be retained.
5. From the back of the washer, remove the wire shipping
clip securing the drain hose.
6. DO NOT remove the PLASTIC CLAMP which secures the
drain hose to the right side of the washer backsheet. It
helps form a standpipe to prevent water siphoning.
PLASTIC
CLIP
7. Carefully move the laundry center to within 4 feet of
the fi nal location for the start of the installation.
13
WIRE CLIP