Publicidad
Idiomas disponibles
Idiomas disponibles
Side burner
[]
Loosenside burner in side shelf. (B). To loosen, unscrew and remove two front screws holding side
burner in place. (A). Note: Do not loosen electrode screw.
[]
Removethe 2 pre-installed screws from the valve stem and set them aside. (C)
[]
Insert valve stem through hole in fascia. (D) Attach bezel to fascia and valve face with previously
removed 2 screws. Attach bezel with black mark facing up (E).
[]
Place side burner tube over the valve, making sure that valve is inside side burner tube. (F)
[]
Pushcontrol knob onto side burner valve stem. (G)
[]
Reattach side burner to side burner shelf with the 2 previously removed screws. Replace side burner
grate. (H)
[]
Connect both igniter wires to the igniter module on the inside of the right fascia. To connect, push
igniter wire tips onto pins in igniter module(I)
[]
Unscrew igniter cap from control panel. Insert (1)AAA battery (provided in blister pack) into battery
slot with positive end (+) facing outward. Screw igniter cap back onto panel. (J)
24 " 146.23680310
Publicidad
