Dandy Designer DER244BSS Manual De Propietario página 19

ELECTRICAL CONNECTIONS
ELECTRICAL REQUIREMENTS
CAUTION
For personal safety, do not use an extension cord with this appliance. Remove house fuse or open circuit breaker
before beginning installation.
• This appliance must be supplied with the proper voltage and frequency, and connected to an individual properly
grounded branch circuit, protected by a circuit breaker or fuse having amperage as specifi ed on the rating plate. The
rating plate is located under the cooktop. See the Lift-Up Cooktop section in this manual for instructions on how to lift
the cooktop.
Rating Plate
1
POWER CORD AND CONDUIT INSTALLATION
A
Remove terminal block cover (on the back of range) by
removing screws using a 1/4" nut driver. Do not discard
these screws.
Back of range
INSTALLATION INSTRUCTIONS
Screw to
remove
terminal
block cover
Terminal block cover
• We recommend you have the electrical wiring and hookup
of your range connected by a qualifi ed electrician. After
installation, have the electrician show you where your main
range disconnect is located.
• Check with your local utilities for electrical codes which
apply in your area. Failure to wire your oven according to
governing codes could result in a hazardous condition. If
there are no local codes, your range must be wired and
fused to meet the requirements of the CSA Standard C22.1,
Canadian Electrical Code, Part 1 - latest edition. You can get
a copy from:
• For USA consumers, we recommend you to have the elec-
trical wiring to reinstall a new power if necessary and follow
power cord and conduit installation.
Terminal block
(appearance
may vary)
17