Kenwood ZJM810 Instrucciones página 6

troubleshooting guide
Problem
Kettle not operating.
Kettle not switching off
automatically after
boiling/Long switch
off time.
Water splashing out of
spout area.
Kettle switching on and
off during use or
switching off before
water boiled.
Kettle stopped working
during operation.
If none of the above solve the problem see "Service & Customer Care".
English
Cause
No Power.
Kettle unplugged.
Kettle overfilled.
Lid not fitted.
Filter not fitted in
spout area.
Limescale/mineral
build up on element
affecting operation.
Boil dry protection
operated due to
insufficient water in
the kettle.
6
Solution
Check kettle is plugged in.
Check kettle is correctly
located to the powerbase.
Check water level is not
above the Max level.
Check lid is fitted correctly.
Always use the filter and do
not overfill above the Max
level.
Check that the element is
free from scale.
Refer to "descaling" section
under care and cleaning.
Switch off and remove from
the powerbase.
Allow to cool down before
refilling.
When the kettle has cooled
down the switch will reset
itself.
Check the water level is
above the minimum level.